Refine your search
Collections
Co-Authors
Journals
Year
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z All
Garg, Rajnish
- Optimization of Friction and Wear Characteristics of Jatropha Oil Based Lubricant and Physio-Chemical Characterization
Abstract Views :304 |
PDF Views:2
Authors
Affiliations
1 Department of Mechanical Engineering, College of Engineering Studies, University of Petroleum and Energy Studies Dehradun (Uttarakhand), IN
1 Department of Mechanical Engineering, College of Engineering Studies, University of Petroleum and Energy Studies Dehradun (Uttarakhand), IN
Source
Engineering and Technology in India, Vol 6, No 2 (2015), Pagination: 64-79Abstract
This investigation reports on the effect of jatropha oil doped with lube oil on tribological characteristics of Al-7per cent Si alloy. The factors involved were jatropha oil percentages, sliding velocities and load which was optimized for weight loss, friction co-efficient and specific wear rate characteristics. The conventional lubricant was SAE 40. It is observed that the jatropha oil percentage factor had significant influence on the weight loss, friction co-efficient and wear rate of the pin. The optimum result was A2B3C1 for pin weight loss, friction co-efficient and wear rate. From the experimental result, it is found that the wear scar diameter increases with the increase of load for lube oil and reduced by addition of percentage of jatropha oil. Flash temperature parameter also studied in this experiment and results shown that 15 per cent addition of jatropha oil would result in less possibility to film breakdown. The overall results of this experiment reveal that the addition of 15 per cent jatropha oil with base lubricant produces better performance and anti-wear characteristics. This blend can be used as lubricant oil which is environment friendly in nature and would help to reduce petroleum based lubricant substantially.Keywords
Taguchi, ANOVA, Pin Weight Loss, Friction Co-efficient, Wear Rate.
References
- Adhvaryu, A., Liu, Z. and Erhan, S. (2015). Synthesis of novel alkoxyllatedtriacylglycerols and their lubricant base oil properties. Indian Crop Prod., 21:113-119.
- Bekal, S. and Bhat, N.R. (2012). Bio-lubricant as an alternative to mineral oil for a CI engine-An experimental investigation with pongamia oil as a lubricant. Energ Source, 34 (11) : 1016-1026.
- Bell, J.C. (1998). Gasoline engine valve train design evolution and the anti-wear requirements of motor oils. J. Engine TRi bolInst Mech. Eng. J., 212 (4): 243-257.
- Bokade, V.V. and Yadav, G.D. (2007). Synthesis of bio-diesel and bio-lubricant by transesterification of vegetable oil with lower and higher alcohols over heteropolyacids supported by clay (K-10). Proc. Saf. Environ. Prot., 85 : 372-377.
- Chen, X.M. and Kitts, D.D. (2008). Determining conditions for nitric oxide synthesis in Caco-2 cells using Taguchi and factorial experimental designs.Anal. Biochem., 381: 185-192.
- Chowdhury, A., Chakraborty, R., Debarati, M. and Biswasa, D. (2014). Optimization of the production parameters of octyl ester biolubricant using Taguchi’s design method and physico-chemical characterization of the product. Indian Crop Prod., 52 : 783-789.
- Ferhat, G. and Acilar, M. (2004). Effect of the reinforcement volume fraction on the dry sliding wear behaviour of Al-10Si/ SiCp compositesproduced by vacuum infiltration technique, Compos. Sci. Technol., 64 : 1959-1966.
- Ficici, F., Ari, V. and Kapsiz, M. (2010). The effects of vortex finder on the pressure drop in cyclone separators. Internat. J. Phy. Sci., 5 (6) : 804-813.
- Havet, L., Blouet, J., Valloire, R., Brasseur, E. and Slomka, D.(2001).Tribological characteristics of some environmentally friendly lubricants. Wear, 248 : 140-146.
- He, Z., Lu, J., Zeng, X., Shao, H., Ren, T. and Liu, W. (2004). Study of the tribological behaviours of S, P-containing triazine derivatives as additives in rapeseed oil. Wear., 257: 389-394.
- Houng, J.Y., Liao, J.H., Wu, J.Y., Shen, S.C. and Hsu, H.F. (2006). Enhancement of asymmetric bioreduction of ethyl 4-Chloro acetoacetate by the design of composition of culture medium and reaction conditions. Proc. Biochem., 42 : 1-7.
- Hwang, H.S. and Erhan, S. Z. (2001). Modification of epoxidized soybean oil for lubricant formulations with improved oxidative stability and low pour point. J. Am. Oil Chem.Soc., 78 : 1179-1184.
- Hwang, H.S. and Erhan, S.Z. (2002). Lubricant base stocks from modified soybean oil. AOCS Press Champaign, IL.
- Kapsiz, M., Durat, M. and Ficici, F. (2011). Friction and wear studies between cylinder liner and piston ring pair using Taguchi design method. Adv. Engg. Softw., 42(8) : 595-603.
- Martín-Alfonso, J.E. and Valencia, C. (2015). Tribological, rheological, and microstructural characterization of oleogels based on EVA copolymer and vegetables oils for lubricant applications. Tribol Internat., 90 : 426-434.
- Polmear, R.,Stark, J.S., Roberts, D. and McMinn, A. (2014). The effects of oil pollution on Antarctic benthic diatom communities over 5 years. Mar. Pollut. Bull., 90 (1-2):33-40.
- Prabhu, T.R. (2015). Effects of solid lubricants, load and sliding Sliding velocity on the tribological behaviour of silica reinforced composites using design of experiments. Mater Design., 77 : 149-160.
- Quinchia, L., Delgado, M., Valencia, C., Franco, J. and Gallegos, C. (2009).Viscosity modification of high-oleic sunflower oil with polymeric additives for the design of new bio-lubricant formulations. Environ. Sci. Technol., 43: 2060-2065.
- Quinchia, L., Delgado, M., Valencia, C., Franco, J. and Gallegos, C. (2010). Viscosity modification of different vegetable oils with EVA copolymer for lubricant applications. Indian Crop Prod., 32 : 607-612.
- Rani, S., Joy, M.L. and Nair, K.P. (2015). Evaluation of physio-chemical and tribological properties of rice bran oil - biodegradable and potential base stoke for industrial lubricants. Indian Crop Prod., 65 : 328-333.
- Rao, R.S., Kumar, C.G., Prakasham, R.S. and Hobbs, P.J. (2008). The Taguchi methodology as a statistical tool for biotechnological applications: a critical appraisal. Biotechnol. J., 3: 510-523.
- Salehizadeh, H., Mousavi, M., Hatamipour, S. and Kermanshahi, K. (2007). Microbial demetallization of crude oil using Aspergillus sp. vanadium oxide octaethyl porphyrin (VOOEP) as a model of metallic petroporphyrins. Iran. J. Biotechnol., 5 : 226-231.
- Salih, N., Salimon, J. and Yousif, E. (2011). The physico-chemical and tribological properties of oleic acid based triester bio lubricants. Indian Crop Prod., 34 : 1089-1096.
- Salih, N., Salimon, J. and Yousif, E. (2012). Synthetic bio lubricant base stocks based on environmentally friendly raw materials. J. King Saud Univ. Sci., 24 : 3221-3226.
- Shahabuddin, M., Masjuki, H.H., Kalam, M.A., Bhuiya, M.M.K. and Mehat, H. (2013). Comparative tribological investigation of bio-lubricantformulated from a non-edible oil source (Jatropha oil). Indian Crop Prod., 47: 323-330.
- Taguchi, G. (1986). Introduction to quality engineering. Asian Productivity Organization, TOKYO, JAPAN.
- Tung, S.C. and Gaob, H. (2003). Tribological characteristics and surface interaction between piston ring coatings and a blend of energy conserving oils and ethanol fuels. Wear., 255 : 1276-1285.
- Uosukainen, E., Linko, Y.Y., Lamsa, M., Tervakangas, T. and Linko, P. (1998). Transesterification of trimethylolpropane and rapeseed oil methyl ester to environmentally acceptable lubricants. J. Am. Oil Chem. Soc., 75 : 1557-1563.
- Walsh, J.W. (2002). Determination of triglyceride composition of vegetable oils using HPLC and evaporative light scattering detection. In: IFT Annual Meeting and Food Expo, Anaheim, California, Session 306.
- Wu, Y., Li, W., Zhang, M. and Wang, X. (2013). Improvement of oxidative stability of trimethylol propanetrioleate lubricant. Thermochim Acta., 559 : 112-118.
- Yasotha, K., Aroua, M.K., Ramachandran, K.B. and Tan, I.K.P. (2006). Recovery of medium-chain-length poly hydroxy alkanoates (PHAs) through enzymatic digestion treatments and ultrafiltration. Biochem. Eng. J., 30 : 260-268.
- Yazdian, F., Hajizadeh, S., Shojaosadati, S.A., Khalilzadeh, R., Jahanshahi, M. and Nosrati, M. (2005). Production of single cell protein from natural gas: parameter optimization and RNA evaluation. Iran. J. Biotechnol., 3 : 235-242.
- Zarei, M., Aminzadeh, S., Zolgharnein, H., Safahieh, A., Ghoroghi, A., Motallebi, A., Daliri, M. and Lotfi, A.S. (2010). Serratiamarcescens B4A chitinase product optimizationusing Taguchi approach. Iran. J. Biotechnol., 8: 252-262.