ICTACT Journal on Microelectronics

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

The Construction And Performance Enhancements Of Ultra High-frequency Range For The Indoor And Outdoor Antennas In Built-in Communication Networks


Affiliations
1 Department of Bio-Medical Engineering, Park College of Engineering and Technology, India
2 Dell Technologies, Bangalore, India
     

   Subscribe/Renew Journal


Digital terrestrial television is a good budget alternative to satellite TV. Its main advantages are excellent image and sound quality and no subscription fees. There is a set-top box (receiver) and antenna for digital TV in smart homes, and a great picture on any TV is guaranteed. The accurate picture is achieved due to a different quality signal transmission system than analogue TV. The digital signal is not subject to interference and interference and depends very little on the distance to the transmitter. The proposed antenna design provides enhancements to the Ultra High Frequency (UHF) range for indoor and outdoor antennas. There are indoor and outdoor antennas for the home and Dutch, respectively, where the antenna is installed. They are divided into active and passive depending on the presence of a built-in signal amplifier operating from the network. If the cable is long, the signal attenuation will be strong, which is very important for receiving meter waves unlike UHF, for which the length of the wire is also important, but not so much.

Keywords

Digital Television, Set-Top Box, Transmission System, Ultra High Frequency, Indoor Antennas, Outdoor Antennas
Subscription Login to verify subscription
User
Notifications
Font Size

  • M. Ikram, N. Nguyen Trong and A.M. Abbosh, “Common-Aperture Sub-6 GHz and Millimeter-Wave 5G Antenna System”, IEEE Access, Vol. 8, pp. 199415-199423, 2020.

  • P. Chen, J. Xia, B.M. Merrick and T.J. Brazil, “Multi Objective Bayesian Optimization for Active Load Modulation in a Broadband 20-W Gan Doherty Power Amplifier Design”, IEEE Transactions on Microwave Theory and Techniques, Vol. 65, No. 3, pp. 860-871, 2017.

  • L. Kouhalvandi, O. Ceylan and S. Ozoguz, “Automated Deep Neural Learning-Based Optimization for High-Performance High-Power Amplifier Designs”, IEEE Transactions on Circuits and Systems I: Regular Papers, Vol. 67, No. 12, pp. 4420-4433, 2020.

  • S.F. Jilani, M.O. Munoz, Q.H. Abbasi and A. Alomainy, “Millimeter-Wave Liquid Crystal Polymer based Conformal Antenna Array for 5G Applications”, IEEE Antennas and Wireless Propagation Letters, Vol. 18, pp. 84-88, 2019.

  • M. Wang, H.F. Ma, H.C. Zhang, W.X. Tang, X.R. Zhang and T.J. Cui, “Frequency-Fixed Beam Scanning Leaky-Wave Antenna using Electronically Controllable Corrugated Microstrip Line”, IEEE Transactions on Antennas and Propagation, Vol. 66, No. 9, pp. 4449-4457, 2018.

  • A. Othman, R. Barrak, G.I. Abib and M. Mabrouk, “A Varactor based Tunable RF Filter for Multistandard Wireless Communication Receivers”, AEU - International Journal of Electronics and Communications, Vol. 102, pp. 69-77, 2019.

  • K. Klionovski and A. Shamim, “Physically Connected Stacked Patch Antenna Design with 100% Bandwidth”, IEEE Antennas and Wireless Propagation Letters, Vol. 16, pp. 3208-3211, 2017.

  • W. Zhang, Z. Weng and L. Wang, “Design of a Dual-Band MIMO Antenna for 5G Smartphone Application”, Proceedings of IEEE International Workshop on Antenna Technology, pp. 1-3, 2018.

  • A. Kumar, A. Ansari, B. Kanaujia, J. Kishor and L. Matekovits, “A Review on Different Techniques of Mutual Coupling Reduction between Elements of any MIMO Antenna. Part 1: DGSs and Parasitic Structures”, Radio Science, Vol. 56, pp. 1-13, 2021.

  • N.O. Parchin, “MM-Wave Phased Array Quasi-Yagi Antenna for the Upcoming 5G Cellular Communications”, Applied Science, Vol. 9, pp. 1-14, 2019.

  • N. Ojaroudiparchin, “MM-Wave Dielectric Resonator Antenna (DRA) with Wide Bandwidth for the Future Wireless Networks”, Proceedings of International Conference on Microwaves, Radar and Wireless Communications, pp. 1-6, 2016.

  • D. Oueslati, R. Mittra and H. Rmili, “Wideband Low-Profile Aperture Antenna for 5G-Applications Comprising of a Slotted Waveguide Array and an Integrated Corporate Feed”, Proceedings of 13th European Conference on Antennas and Propagation, pp. 1-5, 2019.

  • M. Hashemi, C.E. Koksal and N.B. Shroff, “Out-of-Band Millimeter Wave Beamforming and Communications to Achieve Low Latency and High Energy Efficiency in 5G Systems”, IEEE Transactions on Communications, Vol. 66, No. 2, pp. 875-888, 2017.

  • M. Peng and A. Zhao, “High Performance 5G Millimeter-Wave Antenna Array for 37-40 GHz Mobile Application”, Proceedings of International Workshop on Antenna Technology, pp. 1-4, 2018.

  • T. Goel and A. Patnaik, “Novel Broadband Antennas for Future Mobile Communications”, IEEE Transactions on Antennas and Propagation, Vol. 66, No. 5, pp. 2299-2308, 2018.

  • W. Fuscaldo, G. Valerio, A. Galli, R. Sauleau, A. Grbic and M. Ettorre, “Higher-Order Leaky-Mode Bessel-Beam Launcher”, IEEE Transactions on Antennas and Propagation, Vol. 64, No. 3, pp. 904-913, 2016.

  • M. Qi, W. Tang and T. Cui, “A Broadband Bessel Beam Launcher using Metamaterial Lens”, Scientific Reports, Vol. 5, pp. 1-11, 2015.

  • A. Kumar, J. Kaur and R. Singh, “Performance Analysis of Different Feeding Techniques”, International Journal of Emerging Technology and Advanced Engineering, Vol. 3, No. 3, pp. 884-890, 2013.

  • M. Khalily, R. Tafazolli, P. Xiao and A.A. Kishk, “Broadband mm-Wave Microstrip Array Antenna with Improved Radiation Characteristics for Different 5G Applications”, IEEE Transactions on Antennas and Propagation, Vol. 66, No. 9, pp. 4641-4647, 2018.

  • K.H. Sayidmarie and L.S. Yahya, “Double-Monopole Crescent-Shaped Antennas with High Isolation for WLAN and WIMAX Applications”, Proceedings of IEEE International Conference on Antenna Fundamentals for Legacy Mobile Applications and Beyond, pp. 53-70, 2018


Abstract Views: 160

PDF Views: 0




  • The Construction And Performance Enhancements Of Ultra High-frequency Range For The Indoor And Outdoor Antennas In Built-in Communication Networks

Abstract Views: 160  |  PDF Views: 0

Authors

J. Gowri
Department of Bio-Medical Engineering, Park College of Engineering and Technology, India
Indu Nair
Department of Bio-Medical Engineering, Park College of Engineering and Technology, India
Hari Hara Priyadharshini
Dell Technologies, Bangalore, India

Abstract


Digital terrestrial television is a good budget alternative to satellite TV. Its main advantages are excellent image and sound quality and no subscription fees. There is a set-top box (receiver) and antenna for digital TV in smart homes, and a great picture on any TV is guaranteed. The accurate picture is achieved due to a different quality signal transmission system than analogue TV. The digital signal is not subject to interference and interference and depends very little on the distance to the transmitter. The proposed antenna design provides enhancements to the Ultra High Frequency (UHF) range for indoor and outdoor antennas. There are indoor and outdoor antennas for the home and Dutch, respectively, where the antenna is installed. They are divided into active and passive depending on the presence of a built-in signal amplifier operating from the network. If the cable is long, the signal attenuation will be strong, which is very important for receiving meter waves unlike UHF, for which the length of the wire is also important, but not so much.

Keywords


Digital Television, Set-Top Box, Transmission System, Ultra High Frequency, Indoor Antennas, Outdoor Antennas

References