International Journal of Vehicle Structures and Systems

Open Access Open Access  Restricted Access Subscription Access

Effect of Metallic Nano-Additives on Combustion Performance and Emissions of DI CI Engine Fuelled with Palmkernel Methyl Ester


Affiliations
1 Dept. of Mech. Engg., Hindustan Institute of Tech. and Science, Chennai, India
2 Dept. of Automobile Engg., Hindustan Institute of Tech. and Science, Chennai, India
3 School of Mech. Engg., Sathyabama University, Chennai, India
 

   Subscribe/Renew Journal


Compression ignition engines are widely used due to their lower energy consumption and enhanced combustion efficiency. In this experimental investigation, the feasibility of fuelling a single cylinder 4 stroke direct injection compression ignition engine with methyl esters of palmkernel (PME) oil along with various fractions of aluminium oxide nano particles (ANOP) were analysed. Two stage transesterification process was adopted to prepare PME. PME20 blend was formulated and fused using high speed homogenizer with varying proportions of AONP as 25 ppm, 50 ppm and 100 ppm in the presence of hexadecyl trimethyl ammonium bromide as surfactant. The experimental investigations were conducted at rated power of 3.5kW at 1500rpm. It was noticed that supplementation of AONP affected the ignition delay significantly favouring enhanced combustion efficiency. The rate of heat release and in-cylinder pressure was substantially increased with notable reduction in ignition delay. Addition of AONP showed an increase in brake thermal efficiency and exhaust gas temperature with diminution in brake specific energy consumption. The unburned hydrocarbons, carbon monoxide and smoke density decreased sharply with an upsurge in NOx. Increase in AONP concentration up-to 100 ppm with PME20 was found to give better combustion and performance characteristics.

Keywords

Palmkernel Methyl Ester, Transesterification, Nano Particle, Combustion Performance, Ignition Delay.
User
Subscription Login to verify subscription
Notifications
Font Size

  • S. Gumus, H. Ozcan, M. Ozbey and B. Topaloglu. 2016. Aluminum oxide and copper oxide nanodiesel fuel properties and usage in a compression ignition engine, Fuel, 163, 80-87. https://doi.org/10.1016/j.fuel.2015.09.048.

  • Y. Gan and L. Qiao. 2011. Combustion characteristics of fuel droplets with addition of nano and micron-sized aluminium particles, Combustion and Flame, 158, 354-368. https://doi.org/10.1016/j.combustflame.2010.09.005.

  • C.S. Aalam and C.G. Saravanan. 2015. Effects of nano metal oxide blended Mahua biodiesel on CRDI diesel engine, Ain Shams Engg. J.. https://doi.org/10.1016/j.asej.2015.09.013.

  • C.S. Aalam, C.G. Saravanan and M. Kannan. 2015.Experimental investigations on a CRDI system assisted diesel engine fuelled with aluminium oxide nanoparticles blended biodiesel, Alexandria Engg. J., 54, 351-358. https://doi.org/10.1016/j.aej.2015.04.009.

  • Anbarasu, A. Karthikeyan and M. Balaji. 2016. Performance and emission characteristics of diesel engine using alumina nanoparticle blended biodiesel emulsion fuel, ASME Trans. J. Energy Resources Tech., 138, 022203-6.

  • R. Bharathiraja, N. Praveenkumar, K.S.Amirthagadeswaran, S. Periyasamy and K. Rameshbabu.

  • Study on characteristics of CI engine using nano additive blended diesel fuel, Int. J. Applied Engg.

  • Research, 10(67), 328-334.

  • J.S. Basha and R.B. Anand. 2013. The influence of nano additive blended biodiesel fuels on the working characteristics of a diesel engine, J. Braz. Soc. Mech. Sci.Engg., 35, 257-264. https://doi.org/10.1007/s40430-013-0023-0.

  • J.S. Basha and R.B. Anand. 2014. Performance, emission and combustion characteristics of a diesel engine using carbon nanotubes blended jatropha methyl ester emulsions, Alexandria Engg. J., 53, 259-273.

  • https://doi.org/10.1016/j.aej.2014.04.001.

  • A. Selvaganapthy, A Sundar, B. Kumaragurubaran and P.Gopal. 2013. An experimental investigation to study the effects of various nano particles with diesel on DI diesel engine, ARPN J. Sci. and Tech., 3 (1), 112-115.

  • V.A.M. Selvan, R.B. Anand and M. Udayakumar. 2008. effects of cerium oxide nanoparticle addition in diesel and diesel-biodiesel-ethanol blends on the performance and emission characteristics of a CI engine, ARPN J.Engg. and Applied Sci., 4(7), 1-6.

  • A.A.T. Bafghi, H. Bakhoda and F.K. Chegeni. Effects of cerium oxide nanoparticle addition in diesel and dieselbiodiesel blends on the performance characteristics of a CI engine, Int. J. Mech., Aerospace, Industrial, Mechatronic and Manufacturing Engg., 9(8), 1415-1420.

  • S. Tajudeen and R. Velraj. 2014. Nanoadditives: enhancement of combustion and performance characteristics of a CI diesel engine, Int. J. Applied Environmental Sci., 9(4), 1727-1741.

  • J.S. Basha and R.B. Anand. 2011. Role of nanoadditive blended biodiesel emulsion fuel on the working characteristics of a diesel engine, J. Renewable and Sustainable Energy, 3, 1-6. https://doi.org/10.1063/1.3575169.

  • V. Hariram, S. Seralathan, M. Dineshkumar, S.Vasanthaseelan and M. Sabareesh. 2016. Analyzing the fatty acid methyl esters profile of palmkernel biodiesel using GC/MS, NMR and FTIR techniques, 9(4), 3122-3128.

  • V. Hariram and R.V. Shangar. 2015. Influence of compression ratio on combustion and performance characteristics of direct injection compression ignition engine, Alexandria Engg. J., 54, 807-814. https://doi.org/10.1016/j.aej.2015.06.007.

  • A. Selvaganapthy, B. Sundar, P. Kumaragurubaran and Gopal. 2013. An experimental investigation to study the effects of various nanoparticles with diesel on DI diesel engine, APRN J. Sci. Tech., 3(1), 112-115.

  • D. Wook Oh, A. Jain, J.K. Eaton, K.E. Goodson and J.S.Lee. 2008. Thermal conductivity measurement and sedimentation detection of aluminium oxide nanofluids by using the 3ω method, Int. J. Heat & Fluid Flow, 29, 1456-1461. https://doi.org/10.1016/j.ijheatfluidflow.2008.04.007.


Abstract Views: 392

PDF Views: 188




  • Effect of Metallic Nano-Additives on Combustion Performance and Emissions of DI CI Engine Fuelled with Palmkernel Methyl Ester

Abstract Views: 392  |  PDF Views: 188

Authors

V. Hariram
Dept. of Mech. Engg., Hindustan Institute of Tech. and Science, Chennai, India
S. Seralathan
Dept. of Mech. Engg., Hindustan Institute of Tech. and Science, Chennai, India
M. Rajasekaran
Dept. of Automobile Engg., Hindustan Institute of Tech. and Science, Chennai, India
M. Dinesh Kumar
Dept. of Mech. Engg., Hindustan Institute of Tech. and Science, Chennai, India
S. Padmanabhan
School of Mech. Engg., Sathyabama University, Chennai, India

Abstract


Compression ignition engines are widely used due to their lower energy consumption and enhanced combustion efficiency. In this experimental investigation, the feasibility of fuelling a single cylinder 4 stroke direct injection compression ignition engine with methyl esters of palmkernel (PME) oil along with various fractions of aluminium oxide nano particles (ANOP) were analysed. Two stage transesterification process was adopted to prepare PME. PME20 blend was formulated and fused using high speed homogenizer with varying proportions of AONP as 25 ppm, 50 ppm and 100 ppm in the presence of hexadecyl trimethyl ammonium bromide as surfactant. The experimental investigations were conducted at rated power of 3.5kW at 1500rpm. It was noticed that supplementation of AONP affected the ignition delay significantly favouring enhanced combustion efficiency. The rate of heat release and in-cylinder pressure was substantially increased with notable reduction in ignition delay. Addition of AONP showed an increase in brake thermal efficiency and exhaust gas temperature with diminution in brake specific energy consumption. The unburned hydrocarbons, carbon monoxide and smoke density decreased sharply with an upsurge in NOx. Increase in AONP concentration up-to 100 ppm with PME20 was found to give better combustion and performance characteristics.

Keywords


Palmkernel Methyl Ester, Transesterification, Nano Particle, Combustion Performance, Ignition Delay.

References





DOI: https://doi.org/10.4273/ijvss.9.2.08