Manufacturing Technology Today

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Design off a Pneumatic Circuit for Component Assembly


Affiliations
1 Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology (NERIST), Nirjuli-791 109, India
     

   Subscribe/Renew Journal


Pneumatic circuits are designed by various methods. Earlier circuits were designed based on intuitive method which mostly fulfil only the operational requirements. Control aspects and systematic design are evolved by using analytical techniques like Cascade, Karnaugh - Veitch (K-V) diagram, etc., and being used nowadays. In the present investigation, three above methods are analyzed for the component assembly problem. Different features like cost, control aspects, fault diagnosis, etc., are compared and K-V diagram methodology is found more appropriate in many respects, selected for circuit design.
User
Subscription Login to verify subscription
Notifications
Font Size

Abstract Views: 238

PDF Views: 0




  • Design off a Pneumatic Circuit for Component Assembly

Abstract Views: 238  |  PDF Views: 0

Authors

Dipankar Bose
Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology (NERIST), Nirjuli-791 109, India
M. Chandrasekaran
Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology (NERIST), Nirjuli-791 109, India
Santanu Paul
Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology (NERIST), Nirjuli-791 109, India
Proshenjeet Baruah
Department of Mechanical Engineering, North Eastern Regional Institute of Science and Technology (NERIST), Nirjuli-791 109, India

Abstract


Pneumatic circuits are designed by various methods. Earlier circuits were designed based on intuitive method which mostly fulfil only the operational requirements. Control aspects and systematic design are evolved by using analytical techniques like Cascade, Karnaugh - Veitch (K-V) diagram, etc., and being used nowadays. In the present investigation, three above methods are analyzed for the component assembly problem. Different features like cost, control aspects, fault diagnosis, etc., are compared and K-V diagram methodology is found more appropriate in many respects, selected for circuit design.