Current Science

Open Access Open Access  Restricted Access Subscription Access

A Damage Constitutive Model for The Intermittent Cracked Rock Mass Under the Planar Complicated Stress Condition


Affiliations
1 College of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, P.R., China
 

The calculation of rock mass damage induced by the intermittent crack is the premise for establishment of the rock mass damage constitutive model (DCM). However, there are two shortcomings in the previous calculation methods of the rock mass damage: (a) it only considers the crack geometry or strength parameters, and does not consider its deformation parameter such as normal and shear stiffness; and (b) the influence of loading condition of the rock mass is not considered. This study focuses on intermittent cracked rock mass under the planar complicated stress condition and calculates its damage tensor. The proposed calculation method of rock mass damage considers the crack parameter such as length, dip angle, internal friction angle, normal and shear stiffness (internal factor) as well as the loading condition (external factor). The corresponding DCM for the intermittent cracked rock mass is then set up. The calculation examples validate that the proposed model can reflect the influence of crack parameter and loading condition on the rock mass mechanical behaviour.

Keywords

Damage, Intermittent Cracked Rock Mass, Planar Complicated Stress Condition, Stress Intensity Factor, Strain Energy Density Criterion.
User
Notifications
Font Size

  • Wang, T. T. and Huang, T. H., A constitutive model for the deformation of a rock mass containing sets of ubiquitous joints. Int. J. Rock Mech. Min. Sci., 2009, 46(3), 521–530.

  • Wang, T. T. and Huang, T. H., Anisotropic deformation of a circular tunnel excavated in a rock mass containing sets of ubiquitous joints: theory analysis and numerical modeling. Rock Mech. Rock Eng., 2014, 47(2), 643–657.

  • Tokiwa, T. et al., Influence of a fault system on rock mass response to shaft excavation in soft sedimentary rock, Horonobe area, northern Japan. Int. J. Rock Mech. Min. Sci., 2011, 48(5), 773–781.

  • Sari, M., The stochastic assessment of strength and deformability characteristics for a pyroclastic rock mass. Int. J. Rock Mech. Min. Sci., 2009, 46(3), 613–626.

  • Sagong, M. et al., Experimental and numerical analyses of an opening in a jointed rock mass under biaxial compression. Int. J. Rock Mech. Min. Sci., 2011, 48(7), 1055–1067.

  • Khani, A., Baghbanan, A. and Hashemolhosseini, H., Numerical investigation of the effect of fracture intensity on deformability and REV of fractured rock masses. Int. J. Rock Mech. Min. Sci., 2013, 63, 104–112.

  • Kawamoto, T., Ichikawa, Y. and Kyoya, T., Deformation and fracturing behavior of discontinuous rock mass and damage mechanics theory. Int. J. Numer. Analy. Meth. Geomech., 1988, 12, 1–30.

  • Li, N. et al., The mechanical properties and a fatigue-damage model for jointed rock mass subjected to dynamic cyclical loading. Int. J. Rock Mech. Min. Sci., 2011, 38(7), 1071–1079.

  • Prudencio, M. and Van, S. J. M., Strength and failure modes of rock mass models with non-persistent joints. Int. J. Rock Mech. Min. Sci., 2007, 46(6), 890–902.

  • Yang, S. Q. et al., Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression. Int. J. Solids Struct., 2008, 45, 4796–4819.

  • Xie, H. P., Rock and concrete damage mechanics. China University of Mining Sciences and Technology (in Chinese), Xuzhou, 1990.

  • Liu, H. Y. and Yuan, X. P., A compressive damage constitutive model for rock mass with a set of non-persistently closed joints under biaxial conditions. Math. Probl. Eng., 2015, 10.

  • Yang, S. Q., Crack coalescence behavior of brittle sandstone samples containing two coplanar fissures in the process of deformation failure. Eng. Fract. Mech., 2011, 78, 3059–3081.

  • Lemaitre, J., How to use damage mechanics. Nucl. Eng. Des., 1984, 80, 233–245.

  • Huang, C., Subhash, G. and Vitton, S. J., A dynamic damage growth model for uniaxial compressive response of rock aggregates. Mech. Mater., 2002, 34(5), 267–277.

  • Paliwal, B. and Ramesh, K. T., An interacting micro-crack damage model for failure of brittle materials under compression. J. Mech. Phys. Solids, 2008, 56(3), 896–923.

  • Liu, T. Y., Cao, P. and Lin, H., Damage and fracture evolution of hydraulic fracturing in compression-shear rock cracks. Theor. Appl. Fract. Mech., 2014, 74, 55–63.

  • Lee, S. and Ravichandran, G., Crack initiation in brittle solids under multiaxial compression. Eng. Fract. Mech., 2003, 70(13), 1645–1658.

  • Ashby, M. F. and Hallam, S. D., The failure of brittle solids containing small cracks under compressive stress states. Acta. Metall., 1986, 34(3), 497–510.

  • Sih, G. C., Strain-energy-density factor applied to mixed mode crack problems. Int. J. Fract., 1974, 10(3), 305–321.


Abstract Views: 373

PDF Views: 124




  • A Damage Constitutive Model for The Intermittent Cracked Rock Mass Under the Planar Complicated Stress Condition

Abstract Views: 373  |  PDF Views: 124

Authors

Hongyan Liu
College of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, P.R., China
Fengjin Zhu
College of Engineering and Technology, China University of Geosciences (Beijing), Beijing 100083, P.R., China

Abstract


The calculation of rock mass damage induced by the intermittent crack is the premise for establishment of the rock mass damage constitutive model (DCM). However, there are two shortcomings in the previous calculation methods of the rock mass damage: (a) it only considers the crack geometry or strength parameters, and does not consider its deformation parameter such as normal and shear stiffness; and (b) the influence of loading condition of the rock mass is not considered. This study focuses on intermittent cracked rock mass under the planar complicated stress condition and calculates its damage tensor. The proposed calculation method of rock mass damage considers the crack parameter such as length, dip angle, internal friction angle, normal and shear stiffness (internal factor) as well as the loading condition (external factor). The corresponding DCM for the intermittent cracked rock mass is then set up. The calculation examples validate that the proposed model can reflect the influence of crack parameter and loading condition on the rock mass mechanical behaviour.

Keywords


Damage, Intermittent Cracked Rock Mass, Planar Complicated Stress Condition, Stress Intensity Factor, Strain Energy Density Criterion.

References





DOI: https://doi.org/10.18520/cs%2Fv115%2Fi3%2F559-565