Scan Methodology and ATPG DFT Techniques at Lower Technology Node

As VLSI Technology is continuously shrinking to lower technology nodes, we need efficient techniques for testing on lower nodes because as Design Complexity grows, there are numbers of challenges including higher test cost, higher power consumption, test time, area, pin count and new defects at small geometries (variation in transistor’s channel length, W/L ratio, threshold voltage).Reliability and testability both are the important parameters in today’s VLSI design. We use design for testability for this purpose. Scan is the first step for inserting DFT (Design For Testability) architecture in any chip. Thus scan insertion improves the controllability and observability of the sequentially flops. After that pattern generation step is there which is generated by ATPG (Automatic test pattern generation) Tool and finally pattern simulation will give results in terms of pass/fail patterns. The purpose of this paper is to implement scan insertion flow architecture on lower technology nodes and detect the targeted faults through the pattern generation by ATPG which will improve the yield on SOC by fault detection using some EDA tools. It also includes the optimization of the most important test parameters related to testability.