Open Access Open Access  Restricted Access Subscription Access

Dynamic Scheduling of Skippable Periodic Tasks with Energy Efficiency in Weakly Hard Real-Time System


Affiliations
1 Department of Information Technology, Pondicherry Engineering College, Puducherry, India
2 Department of Computer Science and Engineering, Pondicherry Engineering College, Puducherry, India
 

Energy consumption is a critical design issue in real-time systems, especially in battery- operated systems. Maintaining high performance, while extending the battery life between charges is an interesting challenge for system designers. Dynamic Voltage Scaling (DVS) allows a processor to dynamically change speed and voltage at run time, thereby saving energy by spreading run cycles into idle time. Knowing when to use full power and when not, requires the cooperation of the operating system scheduler. Usually, higher processor voltage and frequency leads to higher system throughput while energy reduction can be obtained using lower voltage and frequency. Instead of lowering processor voltage and frequency as much as possible, energy efficient real-time scheduling adjusts voltage and frequency according to some optimization criteria, such as low energy consumption or high throughput, while it meets the timing constraints of the real-time tasks. As the quantity and functional complexity of battery powered portable devices continues to raise, energy efficient design of such devices has become increasingly important. Many real-time scheduling algorithms have been developed recently to reduce energy consumption in the portable devices that use DVS capable processors. Extensive power aware scheduling techniques have been published for energy reduction, but most of them have been focused solely on reducing the processor energy consumption. While the processor is one of the major power hungry units in the system, other peripherals such as network interface card, memory banks, disks also consume significant amount of power. Dynamic Power Down (DPD) technique is used to reduce energy consumption by shutting down the processing unit and peripheral devices, when the system is idle. Three algorithms namely Red Tasks Only (RTO), Blue When Possible (BWP) and Red as Late as Possible (RLP) are proposed in the literature to schedule the real-time tasks in Weakly-hard real-time systems. This paper proposes optimal slack management algorithms to make the above existing weakly hard real-time scheduling algorithms energy efficient using DVS and DPD techniques.

Keywords

Weakly-Hard Real-Time System, Skippable Periodic Task, Energy Efficient Scheduling, DVS, DPD.
User
Notifications
Font Size

Abstract Views: 371

PDF Views: 161




  • Dynamic Scheduling of Skippable Periodic Tasks with Energy Efficiency in Weakly Hard Real-Time System

Abstract Views: 371  |  PDF Views: 161

Authors

Santhi Baskaran
Department of Information Technology, Pondicherry Engineering College, Puducherry, India
P. Thambidurai
Department of Computer Science and Engineering, Pondicherry Engineering College, Puducherry, India

Abstract


Energy consumption is a critical design issue in real-time systems, especially in battery- operated systems. Maintaining high performance, while extending the battery life between charges is an interesting challenge for system designers. Dynamic Voltage Scaling (DVS) allows a processor to dynamically change speed and voltage at run time, thereby saving energy by spreading run cycles into idle time. Knowing when to use full power and when not, requires the cooperation of the operating system scheduler. Usually, higher processor voltage and frequency leads to higher system throughput while energy reduction can be obtained using lower voltage and frequency. Instead of lowering processor voltage and frequency as much as possible, energy efficient real-time scheduling adjusts voltage and frequency according to some optimization criteria, such as low energy consumption or high throughput, while it meets the timing constraints of the real-time tasks. As the quantity and functional complexity of battery powered portable devices continues to raise, energy efficient design of such devices has become increasingly important. Many real-time scheduling algorithms have been developed recently to reduce energy consumption in the portable devices that use DVS capable processors. Extensive power aware scheduling techniques have been published for energy reduction, but most of them have been focused solely on reducing the processor energy consumption. While the processor is one of the major power hungry units in the system, other peripherals such as network interface card, memory banks, disks also consume significant amount of power. Dynamic Power Down (DPD) technique is used to reduce energy consumption by shutting down the processing unit and peripheral devices, when the system is idle. Three algorithms namely Red Tasks Only (RTO), Blue When Possible (BWP) and Red as Late as Possible (RLP) are proposed in the literature to schedule the real-time tasks in Weakly-hard real-time systems. This paper proposes optimal slack management algorithms to make the above existing weakly hard real-time scheduling algorithms energy efficient using DVS and DPD techniques.

Keywords


Weakly-Hard Real-Time System, Skippable Periodic Task, Energy Efficient Scheduling, DVS, DPD.