ICTACT Journal on Microelectronics

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

A Smart Design Of A Multi-dimensional Antenna To Enhance The Maximum Signal Clutch To The Allowable Standards In 5g Communication Networks


Affiliations
1 Department of Electronics and Communication Technology, Sri Eshwar College of Engineering, India
2 Wipro Technologies, Pune, India
     

   Subscribe/Renew Journal


Since the operating range of 5G communication networks is the same as that of the previous generation, there are no difficulties in using these antennas on 5G communication networks. For any technology, the use of antennas makes it possible to bring data rates closer to maximum values. The new technology that uses separate receivers and transmitters on the same frequency band has further increased the speed of receiving and transmitting data. The design of the existing 4G modem provides for the use of antenna technology. The proposed model provides the construction of a multidimensional antenna. The other passive devices it has a one-way direction, which increases the received signal and reduces the amount of interference from the sides to the back. Therefore, the proposed model possible to increase the signal level to acceptable values, even at unstable reception levels thereby increasing the speed of receiving and transmitting the information. The undoubted advantage of panel antennas is their low cost and exceptional reliability. There is practically nothing in the design that can be broken even when falling from a great height. The only weak point is the high-frequency cable, which can break at the point where it enters the case. To extend the life of the device, the cable must be securely connected.

Keywords

5G Communication Networks, Antenna, Data Rate, Transmitters, 4G Modem, Signal Level, Panel Antennas
Subscription Login to verify subscription
User
Notifications
Font Size

  • S. Chen, “Vehicle-to-Everything (V2X) Services Supported by LTE-Based Systems and 5G”, IEEE Communications Standards Magazine, Vol. 1, No. 2, pp. 70-76, 2017.

  • T. Saeidi, I. Ismail, W.P. Wen, A.R. Alhawari and A. Mohammadi, “Ultra-Wideband Antennas for Wireless Communication Applications”, International Journal of Antennas and Propagation, Vol. 2019, pp. 1-12, 2019.

  • Y. He, Y. Chen, L. Zhang, S. Wong and Z.N. Chen, “An Overview of Terahertz Antennas”, China Communications, Vol. 17, No. 7, pp. 124-165, 2020.

  • A. Karmakar, “Fractal Antennas and Arrays: A Review and Recent Developments”, International Journal of Microwave and Wireless Technologies, Vol. 13, pp. 1-25, 2020.

  • W. Hong, “Solving the 5G Mobile Antenna Puzzle: Assessing Future Directions for the 5G Mobile Antenna Paradigm Shift”, IEEE Microwave Magazine, Vol. 18, No. 7, pp. 86-102, 2017.

  • A.D. Boursianis, S.K. Goudos, T.V. Yioultsis, K. Siakavara and P. Rocca, “MIMO Antenna Design for 5G Communication Systems using Salp Swarm Algorithm”, Proceedings of International Workshop on Antenna Technology, pp. 1-3, 2020.

  • A.D. Boursianis, S. Koulouridis, D. Georgoulas and S.K. Goudos, “Wearable 5-Gigahertz Wi-Fi Antenna Design using Whale Optimization Algorithm”, Proceedings of 14th European Conference on Antennas and Propagation, pp. 1-4, 2020.

  • R. Shadid, M. Haerinia and S. Noghanian, “Study of Rotation and Bending Effects on a Flexible Hybrid Implanted Power Transfer and Wireless Antenna System”, Sensors, Vol. 20, No. 10, pp. 1-13, 2020.

  • S. Yang, L. Zhang, J. Fu, Z. Zheng, X. Zhang and A. Liao, “Design and Optimization for 77 GHZ Series-Fed Patch Array Antenna based on Genetic Algorithm”, Sensors, Vol. 20, No. 11, pp. 1-12, 2020.

  • H. Sun, X. Ge, W. He and L. Zhao, “A Reconfigurable Antenna with Sum-and Difference-Patterns for WLAN Access Points”, IEEE Antennas and Wireless Propagation Letters, Vol. 19, No. 7, pp. 1073-1077, 2020.

  • E. Zhang, A. Michel, M. R. Pino, P. Nepa and J. Qiu, “A Dual Circularly Polarized Patch Antenna with High Isolation for MIMO WLAN Applications”, IEEE Access, Vol. 8, pp. 117833-117840, 2020.

  • Q. Li, Q. Chu and Y. Chang, “Design of Compact Highisolation MIMO Antenna with Multi-objective Mixed Optimization Algorithm”, IEEE Antennas and Wireless Propagation Letters, Vol. 19, No. 8, pp. 1306-1310, 2020.

  • T. Aathmanesan and G. Geetharamani, “Design of Metamaterial Antenna for 2.4 GHz WiFi Applications”, Wireless Personal Communication, Vol. 113, pp. 2289-2300, 2020.

  • H. Chen, Y. Tsai, C. Sim and C. Kuo, “Broadband 8-Antenna Array Design for Sub-6GHz 5G NR Bands MetalFrame Smartphone Applications”, IEEE Antennas and Wireless Propagation Letters, Vol. 19, No. 7, pp. 1078-1082, 2020.

  • G. Xie, F. Zhang, S. Liu and Y. Zhao, “A Wideband Dual Polarized Aperture-Coupled Antenna Embedded in a Small Metal Cavity”, IEEE Transactions on Antennas and Propagation, Vol. 89, pp. 1-17, 2020.

  • Y. Liu, W. Zhang, Y. Jia and A. Wu, “Low RCS Antenna Array with Reconfigurable Scattering Patterns Based on Digital Antenna Units”, IEEE Transactions on Antennas and Propagation, Vol. 90, pp. 1-14, pp. 1, 2020.

  • D. Perez-Quintana, A. Torres-Garcia, I. Ederra and M. Beruete, “Compact Groove Diamond Antenna in Gap Waveguide Technology with Broadband Circular Polarization at Millimeter Waves”, IEEE Transactions on Antennas and Propagation, Vol. 68, No. 8, pp. 5778-5783, 2020.

  • C.A. Balanis, “Antenna Theory: Analysis and Design”, John Wiley and Sons, 2016.

  • Yi. Huang and K. Boyle, “Antennas from Theory to Practice”, John Wiley and Sons, 2008.

  • V. Midasala and P. Siddaiah, “Microstrip Patch Antenna Array Design to Improve Better Gains”, Procedia Computer Science, Vol. 85, pp. 401-409, 2016.


Abstract Views: 227

PDF Views: 0




  • A Smart Design Of A Multi-dimensional Antenna To Enhance The Maximum Signal Clutch To The Allowable Standards In 5g Communication Networks

Abstract Views: 227  |  PDF Views: 0

Authors

J. Logeshwaran
Department of Electronics and Communication Technology, Sri Eshwar College of Engineering, India
Karthick Selvaraj
Wipro Technologies, Pune, India

Abstract


Since the operating range of 5G communication networks is the same as that of the previous generation, there are no difficulties in using these antennas on 5G communication networks. For any technology, the use of antennas makes it possible to bring data rates closer to maximum values. The new technology that uses separate receivers and transmitters on the same frequency band has further increased the speed of receiving and transmitting data. The design of the existing 4G modem provides for the use of antenna technology. The proposed model provides the construction of a multidimensional antenna. The other passive devices it has a one-way direction, which increases the received signal and reduces the amount of interference from the sides to the back. Therefore, the proposed model possible to increase the signal level to acceptable values, even at unstable reception levels thereby increasing the speed of receiving and transmitting the information. The undoubted advantage of panel antennas is their low cost and exceptional reliability. There is practically nothing in the design that can be broken even when falling from a great height. The only weak point is the high-frequency cable, which can break at the point where it enters the case. To extend the life of the device, the cable must be securely connected.

Keywords


5G Communication Networks, Antenna, Data Rate, Transmitters, 4G Modem, Signal Level, Panel Antennas

References