International Journal of Agricultural Engineering

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Assessment of Agricultural Mechanization Parameters in Bundelkhand Zone of Uttar Pradesh, India


Affiliations
1 Farm Machinery and Power Engineering, Vaugh School of Agricultural Engineering Technology, Sam Higginbottom University of Agriculture, Technology and Sciences, Allahabad (U.P.), India
     

   Subscribe/Renew Journal


UP is the fifth largest state of India (24.1 million hectares) with a projected population of 220.7 million people (roughly 16.7 % of all-India population) in 2016. It is also one of the poorest states in India with 29.4 per cent of its population below the poverty line (Tendulkar Poverty Line, 2011-12). Agriculture forms an integral part of UP’s economy and the lives of its people. Nearly 69 per cent of land in the state is under cultivation. The state is also divided into 9 agro-climatic zones. Agriculture in Bundelkhand zone was vastly rain-dependent, diverse, complex, under invested, risky and vulnerable mainly because of its geographical condition. A sizeable area of 84 per cent was allocated to food grain crops in this region. Unlike other regions pulses occupied large share i.e. 43 per cent in GCA. Among the cereals wheat was the important crop although its area remained static. This region is lagging far behind in the adoption of the improved varieties and application of fertilizer. The district selected from Bundelkhand agro-climatic zone of Uttar Pradesh was Jhansi and Chitrakoot. Primary data were collected from 100 farmers from 10 villages of 2 districts i.e. 50 farmers from each district. In India, there is a need to increase the availability of farm power from 2.02 kW per ha (2016-17) to 4.0 kW per ha by the end of 2030 to cope up with increasing demand of food grains. The average value of mechanization index, power availability, cropping intensity, irrigation intensity, annual farmer income, annual input cost, human energy, mechanical energy, total energy in Bundelkhand zone of Uttar Pradesh year 2018-19 were in 0.92, 1.61 kW/ha, 124.59 per cent, 124.59 per cent, Rs.119852, Rs.32463, 26.63 kWh/ha, 400.31 kWh/ha and 426.94 kWh/ha, respectively. Still the harvesting with harvesting worker is maximum mechanize i.e. 0.993 then cultivator as well as diesel engine both had almost same value of degree of mechanization i.e. 0.469 and 0.466, respectively.

Keywords

Mechanization Index, Farm Power, Degree of Mechanization, Cropping Intensity, Human Energy, Mechanical Energy, Total Energy.
Subscription Login to verify subscription
User
Notifications
Font Size


  • Almasi, M., Kiani, S. and Loui-mi, N. (2000). Principles of agricultural mechanization. Ma soumeh (PBUH) Publication. Ghom, Iran. pp. 19-40.

  • Andrade, P. and Jenkins, B. (2003). Identification of patterns of farm equipment utilization in two agricultural regions of central and northern Mexico. Agricultural Engineering International: CIGR Journal of Scientific Re-search and Development. Invited Overview Paper., 5: 1-12.

  • Gifford, R.C. and Rijik, A.G. (1980). Guidelines for Agricultural mechanization strategy in development. Economic and Social Commission for Asia and the Pacific (ESCAP), Regional Network for Agricultural machinery.

  • Morris, J. (1985). The economics of small farm mechanization. In: Small farm mechanization for developing countries (eds P. Crossley and Kilgour), pp. 171-184, John Wiley and Sons: New York.

  • Rijk, A.G. (1989). Agricultural mechanization policy and strategy- the case of Thailand. Asian Productivity Organization, Tokyo, Japan.

  • Zangeneh, M.,Omid, M. and Akram, A. (2010). Assessment of agricultural mechanization status of potato production by means of Artificial Neural Network model. Australian J. Crop Sci., 4(5): 372-377.


Abstract Views: 308

PDF Views: 0




  • Assessment of Agricultural Mechanization Parameters in Bundelkhand Zone of Uttar Pradesh, India

Abstract Views: 308  |  PDF Views: 0

Authors

Tarun Kumar Maheshwari
Farm Machinery and Power Engineering, Vaugh School of Agricultural Engineering Technology, Sam Higginbottom University of Agriculture, Technology and Sciences, Allahabad (U.P.), India
Ashok Tripathi
Farm Machinery and Power Engineering, Vaugh School of Agricultural Engineering Technology, Sam Higginbottom University of Agriculture, Technology and Sciences, Allahabad (U.P.), India

Abstract


UP is the fifth largest state of India (24.1 million hectares) with a projected population of 220.7 million people (roughly 16.7 % of all-India population) in 2016. It is also one of the poorest states in India with 29.4 per cent of its population below the poverty line (Tendulkar Poverty Line, 2011-12). Agriculture forms an integral part of UP’s economy and the lives of its people. Nearly 69 per cent of land in the state is under cultivation. The state is also divided into 9 agro-climatic zones. Agriculture in Bundelkhand zone was vastly rain-dependent, diverse, complex, under invested, risky and vulnerable mainly because of its geographical condition. A sizeable area of 84 per cent was allocated to food grain crops in this region. Unlike other regions pulses occupied large share i.e. 43 per cent in GCA. Among the cereals wheat was the important crop although its area remained static. This region is lagging far behind in the adoption of the improved varieties and application of fertilizer. The district selected from Bundelkhand agro-climatic zone of Uttar Pradesh was Jhansi and Chitrakoot. Primary data were collected from 100 farmers from 10 villages of 2 districts i.e. 50 farmers from each district. In India, there is a need to increase the availability of farm power from 2.02 kW per ha (2016-17) to 4.0 kW per ha by the end of 2030 to cope up with increasing demand of food grains. The average value of mechanization index, power availability, cropping intensity, irrigation intensity, annual farmer income, annual input cost, human energy, mechanical energy, total energy in Bundelkhand zone of Uttar Pradesh year 2018-19 were in 0.92, 1.61 kW/ha, 124.59 per cent, 124.59 per cent, Rs.119852, Rs.32463, 26.63 kWh/ha, 400.31 kWh/ha and 426.94 kWh/ha, respectively. Still the harvesting with harvesting worker is maximum mechanize i.e. 0.993 then cultivator as well as diesel engine both had almost same value of degree of mechanization i.e. 0.469 and 0.466, respectively.

Keywords


Mechanization Index, Farm Power, Degree of Mechanization, Cropping Intensity, Human Energy, Mechanical Energy, Total Energy.

References