Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Influence of UV Irradiation on Corrosion Behavior of 304L SS in 0.1M H2SO4 and 0.5M NaCl


Affiliations
1 Raja Ramanna Centre for Advanced Technology, P.O.: CAT, Indore - 452013, Madhya Pradesh, India
2 Project Student, Shri Govindram Seksaria Institute of Technology and Science, Vallabh Nagar, Indore - 452003, India
     

   Subscribe/Renew Journal


This paper describes an experimental study on the effect of Ultra-Violet (UV) exposure on the electrochemical corrosion behavior of 304L stainless steel in 0.1M H2SO4 and 0.5M NaCl medium. The results of study demonstrate that in NaCl medium, exposure of both UV-A and UV-C shifts the Open Circuit Potential (OCP) in active direction (less noble) as compared to the specimen without UV exposure which indicates less stable passive film. While in sulphuric acid both UV-A and UV-C shifts OCP in noble direction which reflects the stability nature of passive film. In H2SO4 medium, exposure of both UV-A and UV-C assist in improving passivity which is indicated by lower passive current density. In NaCl medium, exposure of both UV-A and UV-C, decrease the pitting corrosion resistance as indicated by lower Epit (pitting potential) and higher Icorr (corrosion current density). In H2SO4 uniform dissolution was observed after each polarization experiment as shown in optical micrographs. In NaCl medium pitting sites are more under both type UV exposures as revealed by microstructure after polarization experiment. EIS (Nyquist plots) showed that exposure of both UV-A and UV-C in NaCl medium specimens have lower polarization resistance (Rp) than without UV exposure. Lower Rp confirms lesser protectiveness of passive film. In case of H2SO4, higher arc radius (Rp) is observed under UV exposure for both UV-A and UV-C.

Keywords

Corrosion, Impedance, Open Circuit Potential (OCP), Polarization, Ultra-Violet (UV).
Subscription Login to verify subscription
User
Notifications
Font Size


  • H. Eriksson, S. Bernhardson. Corrosion, 47, 719 (1991). https://doi.org/10.5006/1.3585312.
  • V. Muthupandi, P. Bala Srinivasan, S. K. Seshadri. Mater. Sci. Eng. A., 358, 9 (2003). https://doi.org/10.1016/S0921- 5093(03)00077-7.
  • A. Kocijan, D. Kek-Merl, M. Jenko. Corros. Sci., 53, 776 (2011). https://doi.org/10.1016/j.corsci.2010.11.010.
  • T. L. Sudesh, L. Wijesinghe, D. J. Blackwood. Appl. Surf. Sci. 253, 1006 (2006). https://doi.org/10.1016/j. apsusc.2006.03.081.
  • S. Lenhart, M. Urquidi-Macdonald, D. D. Macdonald. Electrochim. Acta., 32, 1739 (1987). https://doi. org/10.1016/0013-4686(87)80008-7.
  • D. D. Macdonald, E. Sikora, M. W. Balmas, R. C. Alkire. Corros. Sci., 38, 97 (1996). https://doi.org/10.1016/0010- 938X(96)81388-6.
  • C. B. Breslin, D. D. Macdonald, E. Sikora, J. Sikora. Electrochim. Acta., 42, 127 (1997). https://doi. org/10.1016/0013-4686(96)00177-6.
  • S. Fujimoto, T. Yamada, T. Shibada. J. Electrochem. Soc., 145, L79 (1997). https://doi.org/10.1149/1.1838493.
  • P. Schmuki, H. Bohni. Electrochim. Acta., 40, 775 (1995). https://doi.org/10.1016/0013-4686(94)00341-W.
  • H. Luo, X. G. Li, C. F. Dong, K. Xiao, X. Q. Cheng. J. of Phy. and Chem. of Solids., 74, 691 (2013). https://doi. org/10.1016/j.jpcs.2013.01.005.
  • D. D. Macdonald, I. E. Sikora, M. W. Balmas, R. C. Alkire. Corros. Sci., 38, 97 (1996). https://doi.org/10.1016/0010- 938X(96)81388-6.
  • S. Fujimoto, T. Yamada, T. Shibata. J. Electrochem. Soc., 145, L79 (1998). https://doi.org/10.1149/1.1838493.
  • M. G. Mahmoud, R. Wang, M. Kato, K. Nakasa. Scrip. Materi., 53, 1303 (2005). https://doi.org/10.1016/j.scriptamat. 2005.07.039.
  • J. Wu, X. Li, H. Cao, Y. Pan, Y. Zhu. J. of Alloys and Comp., 661, 345 (2016).
  • J. Sedriks. Corrosion of Stainless Steel. John Wiley, New York, (1979).
  • R. K. Gupta, K. Thygarajan, S. Ningshen, U. K. Mudali. J. of Electroche. Socie. of India, 60, 129 (2011).
  • U. K. Mudali, P. Shankar, S. Ningesh, R. K. Dayal, H. S. Khatak, B. Raj. Corros. Sci., 44, 2183 (2002). https://doi. org/10.1016/S0010-938X(02)00035-5.
  • M. Curion, F. Scenini. Electrochim. Acta, 180, 712 (2015). https://doi.org/10.1016/j.electacta.2015.08.076.
  • U. Trdan, J. Grum. Corros. Sci., 82, 324 (2012). https://doi.org/10.1016/j.corsci.2012.03.019.
  • S. Ningshen, U. K. Mudali, S. Ramya, B. Raj. Corros. Sci., 53, 64 (2011). https://doi.org/10.1016/j.corsci.2010.09.023.
  • H. Luo, X. G. Li, C. F. Dong, K. Xiao, X. Q. Cheng. J. of Phy. and Chem. of Solids, 74, 691 (2013). https://doi. org/10.1016/j.jpcs.2013.01.005.

Abstract Views: 290

PDF Views: 1




  • Influence of UV Irradiation on Corrosion Behavior of 304L SS in 0.1M H2SO4 and 0.5M NaCl

Abstract Views: 290  |  PDF Views: 1

Authors

R. K. Gupta
Raja Ramanna Centre for Advanced Technology, P.O.: CAT, Indore - 452013, Madhya Pradesh, India
Sunil Chouhan
Project Student, Shri Govindram Seksaria Institute of Technology and Science, Vallabh Nagar, Indore - 452003, India
P. Ganesh
Raja Ramanna Centre for Advanced Technology, P.O.: CAT, Indore - 452013, Madhya Pradesh, India
R. Kaul
Raja Ramanna Centre for Advanced Technology, P.O.: CAT, Indore - 452013, Madhya Pradesh, India

Abstract


This paper describes an experimental study on the effect of Ultra-Violet (UV) exposure on the electrochemical corrosion behavior of 304L stainless steel in 0.1M H2SO4 and 0.5M NaCl medium. The results of study demonstrate that in NaCl medium, exposure of both UV-A and UV-C shifts the Open Circuit Potential (OCP) in active direction (less noble) as compared to the specimen without UV exposure which indicates less stable passive film. While in sulphuric acid both UV-A and UV-C shifts OCP in noble direction which reflects the stability nature of passive film. In H2SO4 medium, exposure of both UV-A and UV-C assist in improving passivity which is indicated by lower passive current density. In NaCl medium, exposure of both UV-A and UV-C, decrease the pitting corrosion resistance as indicated by lower Epit (pitting potential) and higher Icorr (corrosion current density). In H2SO4 uniform dissolution was observed after each polarization experiment as shown in optical micrographs. In NaCl medium pitting sites are more under both type UV exposures as revealed by microstructure after polarization experiment. EIS (Nyquist plots) showed that exposure of both UV-A and UV-C in NaCl medium specimens have lower polarization resistance (Rp) than without UV exposure. Lower Rp confirms lesser protectiveness of passive film. In case of H2SO4, higher arc radius (Rp) is observed under UV exposure for both UV-A and UV-C.

Keywords


Corrosion, Impedance, Open Circuit Potential (OCP), Polarization, Ultra-Violet (UV).

References





DOI: https://doi.org/10.18311/jsst%2F2020%2F24037