Manufacturing Technology Today

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Modeling and Analysis of Average Cutting Speed in WEDM of SICP/6061 Al Metal Matrix Composite


Affiliations
1 Dept. of Mechanical and Industrial Engg., Indian Institute of Technology, Roorkee, India
2 Dept. of Mechanical Engg., Indian Institute of Technology, Indore, India
     

   Subscribe/Renew Journal


Aluminum metal matrix composite (MMC) is a kind of difficult to machine material. In general it is inefficient if conventional methods are used to machine it, with worse surface quality and serious wear of the cutting tool. This paper reports experimental investigations of the effect of machining parameters namely servo voltage (SV), pulse-on time (TON), pulse-off time (TOFF) and wire feed rate (WF) on average cutting speed during wire electrical discharge machining (WEDM) of SiCp/6061 Al metal matrix composite. Response surface methodology (RSM) has been used to plan and analyze the experiments. Voltage, pulse-off time and wire feed rate were found to have significant effect on average cutting speed.

Keywords

MMC, WEDM, Average Cutting Speed, RSM.
User
Subscription Login to verify subscription
Notifications
Font Size

Abstract Views: 209

PDF Views: 0




  • Modeling and Analysis of Average Cutting Speed in WEDM of SICP/6061 Al Metal Matrix Composite

Abstract Views: 209  |  PDF Views: 0

Authors

Pragya Shandilya
Dept. of Mechanical and Industrial Engg., Indian Institute of Technology, Roorkee, India
P. K. Jain
Dept. of Mechanical and Industrial Engg., Indian Institute of Technology, Roorkee, India
N. K. Jain
Dept. of Mechanical Engg., Indian Institute of Technology, Indore, India

Abstract


Aluminum metal matrix composite (MMC) is a kind of difficult to machine material. In general it is inefficient if conventional methods are used to machine it, with worse surface quality and serious wear of the cutting tool. This paper reports experimental investigations of the effect of machining parameters namely servo voltage (SV), pulse-on time (TON), pulse-off time (TOFF) and wire feed rate (WF) on average cutting speed during wire electrical discharge machining (WEDM) of SiCp/6061 Al metal matrix composite. Response surface methodology (RSM) has been used to plan and analyze the experiments. Voltage, pulse-off time and wire feed rate were found to have significant effect on average cutting speed.

Keywords


MMC, WEDM, Average Cutting Speed, RSM.