Manufacturing Technology Today

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Drilling of Fibre Reinforced Plastic Composites:A Review


Affiliations
1 Dept. of Mechanical Engg., UIET, Panjab University, Chandigarh, India
2 Dept. of Mechanical and Industrial Engg., Indian Institute of Technology, Roorkee, India
     

   Subscribe/Renew Journal


This paper presents comprehensive and exhaustive review of research done in drilling of fibre reinforced plastic composites. Decades of research shows that by keeping the thrust force below a critical value the drilling induced damage can be prevented. Researchers have played with feed rate and tool geometry (point angle, helix angle, and chisel edge angle) so as to keep thrust force below the critical limit. Lately, researchers have tried to devise intelligent drilling process in which feed rate is continuously manipulated such that thrust force is always kept in the safe limit that is below critical value. This paper further represents some important directions for minimal drilling induced damage. Gaps in research, where more effort needs to be put in, are also identified towards the end of the paper.
User
Subscription Login to verify subscription
Notifications
Font Size

Abstract Views: 230

PDF Views: 0




  • Drilling of Fibre Reinforced Plastic Composites:A Review

Abstract Views: 230  |  PDF Views: 0

Authors

Amrinder Pal Singh
Dept. of Mechanical Engg., UIET, Panjab University, Chandigarh, India
Manu Sharma
Dept. of Mechanical Engg., UIET, Panjab University, Chandigarh, India
Inderdeep Singh
Dept. of Mechanical and Industrial Engg., Indian Institute of Technology, Roorkee, India

Abstract


This paper presents comprehensive and exhaustive review of research done in drilling of fibre reinforced plastic composites. Decades of research shows that by keeping the thrust force below a critical value the drilling induced damage can be prevented. Researchers have played with feed rate and tool geometry (point angle, helix angle, and chisel edge angle) so as to keep thrust force below the critical limit. Lately, researchers have tried to devise intelligent drilling process in which feed rate is continuously manipulated such that thrust force is always kept in the safe limit that is below critical value. This paper further represents some important directions for minimal drilling induced damage. Gaps in research, where more effort needs to be put in, are also identified towards the end of the paper.