Manufacturing Technology Today

Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Experimental Investigation of Electrical Discharge Machining of Composites


Affiliations
1 Dept. of Mechanical and Production Engineering, Beant College of Engineering and Technology, Gurdaspur (Pb), India
2 Dept. of Mechanical Engineering, Thapar Institute of Engineering and Technology, Patiala (Pb), India
3 Malout Institute of Management and Information Technology, Malout (Pb), India
     

   Subscribe/Renew Journal


The superior mechanical and physical properties of Metal Matrix Composites (MMCs) make them very attractive for a variety of engineering applications, but machining of MMCs using conventional methods like turning, milling and grinding etc. is not proving much for their progress, it is therefore essential to analyze non-conventional methods for optimum machining of composites. Although Electrical Discharge Machining (EDM) is an important non-conventional process for machining hard materials, yet Its application for composites is relatively less explored. This paper presents some of the results obtained to date from an on going experimental investigations related to EDMIng of 6061 Al/Al2O3 composites. The objective was to find out the effect of EDM parameters viz, discharge current and gap voltage on the machining performance. The responses studies mainly MMR and S. R., and it was observed that the current is distinctly the most significant factor Influencing both the responses.

Keywords

EDM, MMCs, Material Removal Rate, and Surface Roughness.
User
Subscription Login to verify subscription
Notifications
Font Size

Abstract Views: 201

PDF Views: 0




  • Experimental Investigation of Electrical Discharge Machining of Composites

Abstract Views: 201  |  PDF Views: 0

Authors

H. S. Payal
Dept. of Mechanical and Production Engineering, Beant College of Engineering and Technology, Gurdaspur (Pb), India
B. L. Sethi
Dept. of Mechanical Engineering, Thapar Institute of Engineering and Technology, Patiala (Pb), India
Gurdip Singh
Malout Institute of Management and Information Technology, Malout (Pb), India

Abstract


The superior mechanical and physical properties of Metal Matrix Composites (MMCs) make them very attractive for a variety of engineering applications, but machining of MMCs using conventional methods like turning, milling and grinding etc. is not proving much for their progress, it is therefore essential to analyze non-conventional methods for optimum machining of composites. Although Electrical Discharge Machining (EDM) is an important non-conventional process for machining hard materials, yet Its application for composites is relatively less explored. This paper presents some of the results obtained to date from an on going experimental investigations related to EDMIng of 6061 Al/Al2O3 composites. The objective was to find out the effect of EDM parameters viz, discharge current and gap voltage on the machining performance. The responses studies mainly MMR and S. R., and it was observed that the current is distinctly the most significant factor Influencing both the responses.

Keywords


EDM, MMCs, Material Removal Rate, and Surface Roughness.