Reason-A Technical Journal (Formerly Reason-A Technical Magazine)

Open Access Open Access  Restricted Access Subscription Access

Recent Research Works on Burr Minimization in Milling


Affiliations
1 Mechanical Engineering Department, S.M.I.T. (Diploma Engineering Division), Guptipara, Hooghly, West Bengal, India
2 Mechanical Engineering Department, Kalyani Government Engineering College, Kalyani, Nadia, West Bengal, India
 

A burr is an undesirable projection of material formed in machined parts that makes handling as well as assembly of mechanical components difficult, and hence, it needs be subsequently removed, or its formation needs be suppressed to allow the parts to meet desired tolerances, thus, need of deburring will either not be required, or needed to a less extent. A brief overview of techniques to minimize formation of milling burrs is made in this paper.

Keywords

Milling, Burr, In-Plane Exit Angle, Edge Beveling, Control of Burr.
User
Notifications
Font Size


Abstract Views: 469

PDF Views: 191




  • Recent Research Works on Burr Minimization in Milling

Abstract Views: 469  |  PDF Views: 191

Authors

Bhaskar Chakrabarti
Mechanical Engineering Department, S.M.I.T. (Diploma Engineering Division), Guptipara, Hooghly, West Bengal, India
Santanu Das
Mechanical Engineering Department, Kalyani Government Engineering College, Kalyani, Nadia, West Bengal, India

Abstract


A burr is an undesirable projection of material formed in machined parts that makes handling as well as assembly of mechanical components difficult, and hence, it needs be subsequently removed, or its formation needs be suppressed to allow the parts to meet desired tolerances, thus, need of deburring will either not be required, or needed to a less extent. A brief overview of techniques to minimize formation of milling burrs is made in this paper.

Keywords


Milling, Burr, In-Plane Exit Angle, Edge Beveling, Control of Burr.



DOI: https://doi.org/10.21843/reas%2F2011%2F31-36%2F108209