Open Access
Subscription Access
Open Access
Subscription Access
Effects Analysis of Incorporating Suction Line Heat Exchanger (SLHX) Combined with Adiabatic Capillary Tube in Vapor Compression Refrigeration (VCR) System Using R-600a
Subscribe/Renew Journal
This article experimentally analyses the effects of the incorporated Suction Line Heat Exchanger (SLHX) on the performance of vapor compression refrigerators to validate the theoretical relations. The set up uses concentric coiled SLHX combined with adiabatic Capillary tube. The model is based on mass, momentum and energy conservation equations on finite element procedure using R-600a as working fluid. This paper emphasizes on the target design of Domestic refrigerators incorporating such heat exchangers of any refrigeration capacity considering the effect of various geometric and operating parameters on performance of VCR. Here the eco-friendly refrigerant R-600a has additional advantage of low operating pressure range of 0.7 bar to 6 bar claiming for a small size compressor. In the present work the effect of incorporated SLHX on COP has been analyzed theoretically and experimentally and fond to increase by 7% and 3% respectively.
Keywords
Adiabatic Capillary Tube, COP, Fanno Line, Heat Load.
User
Subscription
Login to verify subscription
Font Size
Information
- D. A. Wolf, R. R. Bittle, and M. B. Pate, “Adiabatic capillary tube performance with alternative refrigerants: Final report,” ASHRAE-RP-762, 1995.
- K. C. Sahoo, and S. N. Das, “Phase change pressure drop in capillary of a domestic refrigerator,” IOSR Journal of Mechanical and Civil Engineering, vol. 11, no. 1 ver. III, pp. 79-85, Jan. 2014.
- R. R. Bittle, D. A. Wolf, and M. B. Pate, “A generalized performance prediction method for adiabatic capillary tubes,” HVAC & Research, vol. 14, no. 1, pp. 27-43, 1998.
- ASHRAE, ASHRAE Handbook Refrigeration, Ch. 44, Amer. Soc. Heat. Refrig. Air-cond. Engin., Atlanta, GA, USA., 1994.
- C. Melo, R. T. S. Ferreiraa, C. B. Netoa, J. M.Goncalvesa, and M. M. Mezavilaa, “An experimental analysis of adiabatic capillary tubes,” Applied Thermal Engineering, vol. 19, no. 6, pp. 669-684, 1999.
- S. M. Sami, and H. Maltais, “Experimental analysis of capillary tubes behavior with some R-22 alternative refrigerants,” International Journal of Energy Research, 2000.
- N. E. Hopkins, “Rating the restrictor tube,” Refrigerating Engineering, vol. 58, no. 11, pp. 1087-1095, 1950.
- H. A. Whitesel, “Capillary two-phase flow,” Refrigerating Engineering, p. 42, April 1957.
- ASHRAE Handbook, Equipment Volume, Section II, Refrigeration Equipment, Ch. 20, pp. 1-28, American Society of Heating, Refrigerating, and Air Conditioning Engineers, 1979.
- ASHRAE Refrigeration Handbook, Ch. 45, American Society of Heating, Refrigerating, and Air Conditioning Engineers, 1998.
- E. P. Mikol, “Adiabatic single and two-phase flow in small bore tubes,” ASHRAE Journal, vol. 5, no. 11, pp. 75-86, 1963.
- T. A. Hussain, “A numerical analysis of adiabatic capillary tube performance in vapor compression refrigeration system,” The Iraqi Journal for Mechanical and Material Engineering, vol. 8, no. 3, 2008.
- M. Ramgopal, “NPTEL tutorial on refrigeration & air conditioning,” lesson 24, IIT Kharagpur.
- C. P. Arora, “Expansion devices,” Refrigeration and Air Conditioning, Ch. 8, New Delhi, Mc Graw-Hill.
- R. C. Arora, “Expansion valves,” Refrigeration and Air Conditioning, Ch. 9, PHI, Delhi.
- C. Z. Wei, Y. T. Lin, C. C. Wang, and J. S. Lev, “An experimental study of the performance of capillary tubes for R-407C refrigerant,” ASHRAE Trans., vol. 27, 2001.
Abstract Views: 471
PDF Views: 7