Journal of Pure and Applied Ultrasonics

Open Access Open Access  Restricted Access Subscription Access

PC Based Design of Single Pulse Sender/Receiver Technique for Ultrasonic Velocity Measurements


Affiliations
1 Department of Electronics, Nagpur University Campus, Nagpur-440 010, India
2 Department of Electronics, S. K. Porwal College, Kamptee, Nagpur-441 002, India
3 Department of Electronics, J. B. Science College, Wardha-442 001, India
 

The most popular and effective technique for ultrasonic velocity measurements is the pulse technique. In the present work, a computer based single-pulse sender/receiver technique is designed in the laboratory using indigenous components and a PCL-812 ADC card. A program written in C controls the pulse generation, detection and travel time measurement. An r.f. burst of 2 MHz of 5μS width is obtained from the ADC card. This pulse is amplified and sent to the transmitting transducer. The received pulse is detected and processed by the ADC card for determining the travel time and displays the ultrasonic velocity of propagation in the system on the computer screen. The system developed in the laboratory has been tested for the ultrasonic velocity measurements in different standard liquids. It has been found that the ultrasonic velocity measurements carried out using the above system matches well with those reported in the literature.
User
Notifications
Font Size

Abstract Views: 241

PDF Views: 0




  • PC Based Design of Single Pulse Sender/Receiver Technique for Ultrasonic Velocity Measurements

Abstract Views: 241  |  PDF Views: 0

Authors

S. Rajagopalan
Department of Electronics, Nagpur University Campus, Nagpur-440 010, India
S. J. Sharma
Department of Electronics, S. K. Porwal College, Kamptee, Nagpur-441 002, India
V. M. Ghodki
Department of Electronics, J. B. Science College, Wardha-442 001, India

Abstract


The most popular and effective technique for ultrasonic velocity measurements is the pulse technique. In the present work, a computer based single-pulse sender/receiver technique is designed in the laboratory using indigenous components and a PCL-812 ADC card. A program written in C controls the pulse generation, detection and travel time measurement. An r.f. burst of 2 MHz of 5μS width is obtained from the ADC card. This pulse is amplified and sent to the transmitting transducer. The received pulse is detected and processed by the ADC card for determining the travel time and displays the ultrasonic velocity of propagation in the system on the computer screen. The system developed in the laboratory has been tested for the ultrasonic velocity measurements in different standard liquids. It has been found that the ultrasonic velocity measurements carried out using the above system matches well with those reported in the literature.