Journal of Scientific and Industrial Research

Open Access Open Access  Restricted Access Subscription Access

Pulsating Air Pollinator for Greenhouse Cultivation


Affiliations
1 Division of Agricultural Engineering, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
2 Division of Agricultural Engineering, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
3 Division of Design of Experiments, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
4 Centre for Protected Cultivation Technology, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India

Greenhouses have been accepted worldwide for round-the-year cultivation of quality produce. Greenhouse provides a desired climatic condition for crops but, at the same time, has obstacles for natural pollination. A pollinator was designed on the principle of pulsating air jet for pollination. The pollinator was developed with 3D printed three pulsation units with a provision for varied air pulsation frequency and angular movement to cover the complete flower bed. An operator in the greenhouse alleys can easily move this. The developed pollinator was compared with hand pollination and pollination by a blower in tomato crops. The effects of Airflow rates, Pulsation frequencies of air and Exposure times on pollination efficiency and yield were studied. Experiments were performed in tomato plants cultivated in the greenhouse. The highest pollination efficiency (83.66%) was achieved at 1.99 m3/min airflow rate, 23.50 Hz pulsation frequency and exposure time of 19.40 seconds; Average yield of 19.52 kg was observed at 1.99 m3/min of airflow rate, 22.25 Hz of pulsation frequency and exposure time of 15.78 seconds in flowers of 5 m length sections. The yield was also higher with developed pollinator compared to pollination by a blower (36.6%) and controlled plot (95.7%).
User
Notifications
Font Size

Abstract Views: 143




  • Pulsating Air Pollinator for Greenhouse Cultivation

Abstract Views: 143  | 

Authors

Akshay Sanjay Mahadik
Division of Agricultural Engineering, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
H L Kushwaha
Division of Agricultural Engineering, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
Adarsh Kumar
Division of Agricultural Engineering, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
Arpan Bhowmik
Division of Design of Experiments, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India
Awani Kumar Singh
Centre for Protected Cultivation Technology, ICAR-Indian Agricultural Research Institute, New Delhi 110012, India

Abstract


Greenhouses have been accepted worldwide for round-the-year cultivation of quality produce. Greenhouse provides a desired climatic condition for crops but, at the same time, has obstacles for natural pollination. A pollinator was designed on the principle of pulsating air jet for pollination. The pollinator was developed with 3D printed three pulsation units with a provision for varied air pulsation frequency and angular movement to cover the complete flower bed. An operator in the greenhouse alleys can easily move this. The developed pollinator was compared with hand pollination and pollination by a blower in tomato crops. The effects of Airflow rates, Pulsation frequencies of air and Exposure times on pollination efficiency and yield were studied. Experiments were performed in tomato plants cultivated in the greenhouse. The highest pollination efficiency (83.66%) was achieved at 1.99 m3/min airflow rate, 23.50 Hz pulsation frequency and exposure time of 19.40 seconds; Average yield of 19.52 kg was observed at 1.99 m3/min of airflow rate, 22.25 Hz of pulsation frequency and exposure time of 15.78 seconds in flowers of 5 m length sections. The yield was also higher with developed pollinator compared to pollination by a blower (36.6%) and controlled plot (95.7%).