Open Access Open Access  Restricted Access Subscription Access
Open Access Open Access Open Access  Restricted Access Restricted Access Subscription Access

Finite Element Analysis Mast Assembly of Material Handling Equipment


Affiliations
1 Nagpur Institute of Technology Nagpur, India
     

   Subscribe/Renew Journal


The present work involved the optimization of fork lift mast design so as to controlled the deflection, maximum shear stress, von-mises stress, this work compare the stresses in the structural steel and gray cast iron material for the same loading condition. The stress distribution has been analyzed using ANSYS 11 software for which maximum shear stress; equivalent shear stress at critical area has been calculated. Structural behavior of mast under loading and boundary condition using analytical model is very difficult. Therefore 3D solid model has been chosen in order to predict the detailed stress.

Keywords

Finite Element Analysis, Forklift, Mast, Stationary Member, Elevating Member.
Subscription Login to verify subscription
User
Notifications
Font Size


  • H. Yamamoto and S.T akahara ‘Engine Powered Forklift Truck 1- to 3.5-ton’. Series LEO NXT – V’. Industrial Products, Vol.51, no 115, 2005,
  • Toyota Industrial Equipment September 2007.
  • F. Javier, M. Mazo and M.A. Sotelo ‘ Automation of an Industrial fork lift truck Guided by Artificial Vision in open environments’ Autonomous Robots, vol.5, 1998. p 215-231.
  • R. Santos and D. Riesland ‘Tip- Over Stability Analysis of a Rough Terrain Telescoping forklift”.North American MDI User Conference, 2001, p 1-13.
  • S. Jagar Lamudi.’ Failure Rate Studies and Design Alternatives for Standup Forklift Truck’. 2004.
  • Hiroyuke, B. Makoto, “Development of steer-by-wire system for forklift truck, ”Toyota Industrial Technical R eview.Vol.1, No.44, pp.35-39, Japan, 2002.

Abstract Views: 853

PDF Views: 0




  • Finite Element Analysis Mast Assembly of Material Handling Equipment

Abstract Views: 853  |  PDF Views: 0

Authors

A.T. Meshram
Nagpur Institute of Technology Nagpur, India

Abstract


The present work involved the optimization of fork lift mast design so as to controlled the deflection, maximum shear stress, von-mises stress, this work compare the stresses in the structural steel and gray cast iron material for the same loading condition. The stress distribution has been analyzed using ANSYS 11 software for which maximum shear stress; equivalent shear stress at critical area has been calculated. Structural behavior of mast under loading and boundary condition using analytical model is very difficult. Therefore 3D solid model has been chosen in order to predict the detailed stress.

Keywords


Finite Element Analysis, Forklift, Mast, Stationary Member, Elevating Member.

References