Indian Journal of Science and Technology

Open Access Open Access  Restricted Access Subscription Access

Optimum Design of Boost Converter for Charging the Battery by Non-Conventional Energy Source


Affiliations
1 Mechanical Engineering Department, JNTUA College of Engineering, Anantapur-515 002, India
2 ECE Department, JNTUA College of Engineering, Anantapur-515 002, India
3 Energy Systems, JNTUA College of Engineering, Anantapur-515 002, India
 

The utilization of battery can be improved by designing an appropriate charger capable of fast charging. Photovoltaic panel is used as input source for converter. The objective of this paper is to investigate the converter topologies and control techniques for fast charging of a battery which are required for its optimum design. A charging monitoring system is implemented based on converter technologies. Experimental simulation work is carried out in MATLAB-7.7b. A PI-gain controller feedback is used with reference voltage of 15 V for the ripple free output voltage.

Keywords

Converter Technology, Fast Charging, Matlab Based Monitoring System
User

  • Basu S and Underland TM (2005) Inductor design considerations for optimizing performance & cost of continuous mode boost PFC converter. IEEE Trans. Power Electron. (11) ,1133–1138.

  • Chattopadhyay S, Ramanarayanan V and Jayashankar V (2000) A predictive switching modulator for current mode control of high power factor boost rectifier. Proc. 31st Ann. IEEE Power Electronics Specialists Conf. (1), 371-376.

  • Maksimovic’ D, Jang Y and Erickson RW (1996) Nonlinear-carrier control for high-power-factor boost rectifiers, IEEE Trans. Power Electron. (11), 578–584.

  • Rai GD (2008) Non conventional energy sources, Khanna publishers, 4th edn, 180-190.

  • Robbins T and Hawkins J (1994) Battery model for over current protection simulation of DC distribution systems, IEEE Trans., (4), 307-314.

  • Singh MD and Khanchandani KB (2007) Power electronics, Tata Mc-Graw Hill, 2nd edn., 515-520.


Abstract Views: 458

PDF Views: 176




  • Optimum Design of Boost Converter for Charging the Battery by Non-Conventional Energy Source

Abstract Views: 458  |  PDF Views: 176

Authors

G. Prasanthi
Mechanical Engineering Department, JNTUA College of Engineering, Anantapur-515 002, India
V. Sumalatha
ECE Department, JNTUA College of Engineering, Anantapur-515 002, India
A. Sudheer
Energy Systems, JNTUA College of Engineering, Anantapur-515 002, India

Abstract


The utilization of battery can be improved by designing an appropriate charger capable of fast charging. Photovoltaic panel is used as input source for converter. The objective of this paper is to investigate the converter topologies and control techniques for fast charging of a battery which are required for its optimum design. A charging monitoring system is implemented based on converter technologies. Experimental simulation work is carried out in MATLAB-7.7b. A PI-gain controller feedback is used with reference voltage of 15 V for the ripple free output voltage.

Keywords


Converter Technology, Fast Charging, Matlab Based Monitoring System

References





DOI: https://doi.org/10.17485/ijst%2F2010%2Fv3i7%2F29802