![Open Access](https://i-scholar.in/lib/pkp/templates/images/icons/fulltextgreen.png)
![Restricted Access](https://i-scholar.in/lib/pkp/templates/images/icons/fulltextred.png)
Performance and Emissions Characteristics of a Diesel Engine with Various Injection Pressures Using Biodiesel
This paper presents the suitability of Pongamia methyl ester oil as a source of renewable fuel substituting petrodiesel in CI engine. The properties of esterified Pongamia oil are closer to diesel properties. In the present work, experiment is conducted in a single cylinder direct injection diesel engine fuelled with diesel and 100% Pongamia methyl ester as fuel at different injection pressure at varying loads. The injection pressures are varying from 180 bar to 220 bar. The performance parameters like brake specific fuel consumption (BSFC), brake thermal efficiency (BTE), and exhaust emissions (CO, HC, NOx and smoke) were measured and analyzed. The results indicated that the brake thermal efficiency is increased about 1.5% for 100% PME at 220 bar injection pressure. The BSFC, CO and Smoke were decreased about 7%,33% and 25% respectively for 100% PME at 220 bar compared to 180 bar injection pressure. The nitrogen oxide emission (NO) was increased about 10% for 100% PME with 220 bar injection pressure. However pure Pongamia methyl ester (by volume) can be used at higher injection pressure safely in a conventional CI engine without any engine modification that could help in controlling air pollution.
Keywords
Biodiesel, Diesel Engine, Pongamia Methyl Ester
User
Information
- Rosca R and Zugravel M (1997) The use of sunflower oil in Diesel engines. SAE Paper. No. 972979. pp: 105–111.
- Lapuerta M, Armas O and Rodriguez-Fernandez J (2008) Effect of bio-diesel fuels on diesel engine emissions. Progress in Energy & Combustion Sci. 34, 198–223.
- Heywood JB (1998) Internal combustion engines fundamentals. McGraw Hill Intl. Editions. Singapore. pp: 550–553.
- Ganesan V (1994) Internal Combustion Engines. Tata McGraw Hill, New Delhi. pp: 205–210. 5. Canakci M and Van gerpen J (2001) Biodiesel production from oils and fats with high free fatty acids. Trans. ASME. 44(6), 1429-1436.
- Pramanik K (2003) Properties and use of Jatropha curcas oil and diesel fuel blends in compression Ignition Engine. Renewable Energy. 28 239–248.
- Pandian M, Sivapirakasam SP and Udayakumar M (2009) Influence of injection timing on performance and emission characteristics of naturally aspirated twin cylinder CIDI engine using bio-diesel blend as fuel. Intl. J. Recent Trends in Eng. 1(5), 113-117.
- Shivakumar, Srinivas Pai P, Shrinivasa Rao BR and Samaga BS (2010) Performance and emission characteristics of a 4 stroke c.i. Engine operated on honge methyl ester using artificial neural network. ARPN J. Eng. & Appl. Sci. 5(6), 83-94.
- Dorado MP, Ballesteros E, Arnal JM, G_omez J and L_opez FJ (2003) Exhaust emissions from a diesel engine fuelled with transesterified waste olive oil. Fuel. 82(11), 1311–1315.
- Nazar J, Ramesh A and Nagalingam B (2004) Performance and emission characteristics of a diesel Engine using coconut oil and its methyl ester. ISTE National Conf. Alternate Fuels for Automobiles, IRTT, Erode. pp: 24-31.
- Deepak Agarwal, Shailendra Sinha and Avinash Kumar Agarwal (2006) Experimental investigation of control of NOx emissions in biodiesel-fueled compression ignition engine. Renewable Energy. 31, 2356-2369.
- Lakshmi Narayana Rao G, Saravanan S, Sampath S and Rajagopal K (2008) Combustion and emission characteristics diesel engine fuelled with rich bran oil methyl ester and its diesel blends.Thermal Sci. 12(1), 139-150.
- Malaya Naik LC Meher (2008) Production of biodiesel from high free fatty acids of Karanja (Pongamia pinnatta) oil. Biomass & Bioenergy. 32(4), 354–357.
![](https://i-scholar.in/public/site/images/abstractview.png)
Abstract Views: 508
![](https://i-scholar.in/public/site/images/pdfview.png)
PDF Views: 141