Indian Journal of Pure and Applied Physics

Open Access Open Access  Restricted Access Subscription Access

Indigenously Designed and Fabricated Mechanical Milling set-up to Synthesis Nanoparticles: A Cost-effective Method


Affiliations
1 Department of Studies in Physics, Karnatak University, Dharwad, Karnataka 580 003, India
2 Department of Physics, SRM TRP Engineering College, Tiruchirappalli, Tamil Nadu 621 105, India

In recent days, the area of nanomaterial synthesis has been very attractive due to the distinguished physicochemical properties which can be modified with a different nanostructure and morphology. In this present investigation, a simple and unique approach on fabrication and testing of homemade ball milling has been developed for laboratory use. In the set-up, the gears have been used to provide positive drive over the container by meshing teeth with driver and driving shaft. Just by changing the position of gears horizontally, the different sized container can be mounted for the same set-up based on the requirement. Container was made of stainless-steel metal; it was then threaded on both sides to suit the stainless-steel caps using a lath system and made easy for cleaning container. Reduction of size of the Fe2O3 particles was achieved in short period of time. The particle size of pure and ball milled samples from scanning electron microscope was 227-36 nm. Whereas, the particle analyzer measurement shows that particle size ranges from 230-22 nm.
User
Notifications
Font Size

Abstract Views: 107




  • Indigenously Designed and Fabricated Mechanical Milling set-up to Synthesis Nanoparticles: A Cost-effective Method

Abstract Views: 107  | 

Authors

Chetan Chavan
Department of Studies in Physics, Karnatak University, Dharwad, Karnataka 580 003, India
Rajashekhar F Bhajantri
Department of Studies in Physics, Karnatak University, Dharwad, Karnataka 580 003, India
Soumya S Bulla
Department of Studies in Physics, Karnatak University, Dharwad, Karnataka 580 003, India
SAKTHIPANDI K
Department of Physics, SRM TRP Engineering College, Tiruchirappalli, Tamil Nadu 621 105, India

Abstract


In recent days, the area of nanomaterial synthesis has been very attractive due to the distinguished physicochemical properties which can be modified with a different nanostructure and morphology. In this present investigation, a simple and unique approach on fabrication and testing of homemade ball milling has been developed for laboratory use. In the set-up, the gears have been used to provide positive drive over the container by meshing teeth with driver and driving shaft. Just by changing the position of gears horizontally, the different sized container can be mounted for the same set-up based on the requirement. Container was made of stainless-steel metal; it was then threaded on both sides to suit the stainless-steel caps using a lath system and made easy for cleaning container. Reduction of size of the Fe2O3 particles was achieved in short period of time. The particle size of pure and ball milled samples from scanning electron microscope was 227-36 nm. Whereas, the particle analyzer measurement shows that particle size ranges from 230-22 nm.